Verilink WANsuite 6450, Reference Manual

Page: 68 / 205

3-40 W A N s u i t e 6 4 5 0
Details screen (Figure 3.24 on page 3-25), select “CES” from the “Type”
pull-down menu.
2
On the Serial screen (Figure 3.17 on page 3-19), configure the Serial
interface to your requirements. You must set the “Mode” parameter to
“DCE.” If the required time slots for the Serial interface are contiguous and
not already allocated to the CBR port, you may allocate the required
channels on the Serial screen. If you have not allocated channels for the
Serial interface on the Serial screen, use the Channel Table Details screen
(Step 3 below) to specify the channels for the Serial CES service.
3
On the Channel Table Details screen (Figure 3.33 on page 3-37), set the
desired channel’s “Rate” parameter to “64K,” and the “Service” parameter
to the Service Index for the Serial interface (5).
Valid Channel Ranges for Serial and CBR Interfaces
The range of channels available to the Serial interface depends on the type of
CES service. The table below shows the range of channels available to the
Serial and CBR interfaces for each type of CES service. The type of CES
service and the SHDSL data rate shown in the table on page 3-38 limit the total
number of channels that can be allocated to the Serial interface.