Verilink WANsuite 6450, Reference Manual

Page: 59 / 205

W e b S e r v e r I n t e r f a c e 3-31
Operation Status Current Operation Status.
Values: Up, Down, Testing
Last Change Time and date of the Last Change.
QOS Profile Current QOS profile in use. The default profile is 0 (zero), which is used for
UBR traffic.
When QOS profile “0” is used, the available bandwidth will be equally shared
among all configured channels. QOS “0” cannot be modified.
If one virtual channel requires more bandwidth than others, configure another
QOS profile and set its peak cell rate (PCR) to the required value. However,
the sum of the PCRs of all configured channels must be no greater than the
available AAL5 bandwidth. The available PCR on an SHDSL-ATM link with
a line rate of 2304 kbps is about 5433 cells per second. When
oversubscription is used, the sum of the PCRs for VBR or UBR channels may
exceed the AAL5 bandwidth.
Encapsulation Type Encapsulation Type used. Default is Routed IP, which uses RFC 1483 LLC
encapsulation. If Serial PPP is selected, PPP traffic received from the Serial
port will be sent over the ATM port using RFC 1483 PPPoA encapsulation.
There can be only one VCI configured for Serial PPP.
Serial HDLC is similar to Serial PPP except, when you select Serial HDLC,
data is encapsulated transparently. Any type of HDLC traffic will be
supported. Because this is not a standard encapsulation, a WANsuite unit
must reside at each end of the connection. Even if Serial HDLC or Serial PPP
encapsulation is configured, routed IP traffic received on this channel will be
forwarded to the IP Gateway, if IP Gateway is configured.
Values: Serial PPP, Routed IP, Serial HDLC
Traffic Type Traffic type used. This is a read-only parameter.
Values: CBR, UBR, VBR
Row Status Current status of the VCC.
Values: Active, Not In Service, Not Ready
Adding a New Virtual Channel
To create a new virtual channel, enter the desired VPI/VCI values in the
appropriate fields near the bottom of the screen and click on the “Add Virtual
Channel” button.
If the newly added virtual channel is within the maximum VCC parameter, it
will be activated immediately.
NOTICE:
When adding a Virtual Channel,
the value for VPI may be 0 and
above, but for VCI, must be 32 and above.