Verilink WANsuite 6450, Reference Manual

Page: 26 / 205

2-2 W A N s u i t e 6 4 5 0
For specific applications, see Connector Pin Assignments on page A-6 for
additional optional cables and adapters. Contact Verilink Technical Support
(page xii) for further assistance.
Installation Wizard
The WANsuite 6450 can be configured and monitored through the Web server
interface. To gain access to this interface, the unit must be configured with an
IP Address. Verilink provides a DOS-based program – the Verilink
Configuration Wizard – to aid in this initial configuration.
NOTICE:
You may also access the Verilink Configuration Wizard on the
Verilink Web site: www.verilink.com.
To configure the IP Address using the Verilink Configuration Wizard, perform
the following steps:
1
Using the supplied cable, connect the unit’s DB-9 Supervisory port to a
COM port on your PC. (Take note of which COM port is connected.)
2
Insert the Verilink CD (provided with the WANsuite 6450) into your PC’s
CD-ROM drive.
3
Use Windows “Explore” to view the contents of the CD and select the
folder labeled “Utilities.” In this folder will be a file named
ipwiz.exe
;
this executable file is the Verilink Configuration Wizard application.
Double-click on this file to launch the program. After the program is fully
launched, you will see the following screen:
4
Using the Tab key to move from field to field, move the cursor to the “COM
Port” field. Using the Spacebar, toggle between the available options until
the correct COM port is shown (COM1, COM2, COM3, or COM4). Be sure
to choose the same COM port as the port to which the unit is connected.
5
By default, the “Baud Rate” field will display 115200 (bits per second). For
the purpose of this installation, do not change the displayed baud rate from
its default. Proceed directly to the next step.