Verilink WANsuite 6450, Reference Manual

Page: 47 / 205

W e b S e r v e r I n t e r f a c e 3-19
Figure 3.17 Serial Screen
Type Selects the type of interface (based on its electrical signal characteristics) used
by the equipment connected to the Serial port.
Values: V.35, V.36, RS-232, EIA-530, and X-21
Default: V.35
NOTICE:
V.35 requires the use of an optional cable. Refer to "Connector Pin
Assignments" on page A-6 for ordering information.
Mode By default, the Serial port serves as a DCE port. However, the Serial port can
serve as a DTE port.
If the Serial port connects to a DTE device (such as a FRAD or a router), the
Mode parameter must be set to “DCE.” If this port connects to a DCE device
(such as a DSU/CSU), this parameter must be set to “DTE.”
Values: DCE, DTE
Default: DCE
NOTICE:
DTE mode requires the use of an optional DTE cable. Refer to
"Connector Pin Assignments" on page A-6 for ordering information.
NOTICE:
When you configure the Serial port for CES, you must set the port mode
to DCE.
Packet Rate Packet Rate must be configured to the desired port speed (in bits per second).
Values: 64
−
2304 kbps
Default: 2048 kbps
Bundling Selects whether the DTE channel assignment is made as a “Contiguous”
group or as “Alternate” channels. Selecting “Alternate” ensures ones density.