Vemco HR2, User Manual

Page: 69 / 212

Show Defaults
If you've made any changes to the Session Baud Rate or have checked the RS485 Termination option,
clicking the Show Defaults button will return the settings to their default values (12MBd baud rate, and
no RS485 Termination).
Apply Settings
When done with settings, click Apply Changes . The new settings take effect immediately.
3.7.3 Hardware Status
The Hardware Status section displays the following information:
l
Fault Conditions and View Faults option
- Displays the number of receiver faults (error
conditions), if any currently exist.
l
Reset options - Click more to display the available reset options for the receiver.
Faults
Upon connecting to an HR2 Receiver, Fathom performs a check of the receiver's state. If any faults are
found, you will be presented with a fault diagnosis message.
Figure 3-34: Sample start-up fault condition message
WARNING: This warning only appears on start-up/connection to the receiver. It is critical that you take
corrective action as recommended in the fault message.
There are three fault levels, as described next.
Level Recommended Action
High Discontinue receiver use and contact VEMCO Support immediately .
Medium Replace the battery if that is indicated in the fault description or
Contact VEMCO Support for all others.
Low None required.
Click OK to clear the start-up fault warning message and return to the Fathom interface.
60
HR2 Receiver User Guide