VeEX RXT3900, User Manual

Page: 202 / 383

the loopback that is in place.
Go back to top Go back to TOC
13.3.2 BERT Results
13.3.2.1 Summary
Summary tab:
The following results including the Start (ST) and Elapsed (ET) times are displayed:
Line Rate
(Mbps)
:
Negotiated rate of the interface (10M, 100M, or 1000M). This value is always fixed since it depends on
the maximum capacity of the link under test, hence the test interface that is configured.
Framed Rate:
(P MAC/IP VLAN Tag + Type/ CRC) / (P Total Overhead) * Line Rate
% (in Mbps).
Data Rate:
Payload / (P Total Overhead) * Line Rate %.
Utilization:
% of Line Rate. For example, if we transmit 100Mbps on a 1Gbps interface then the utilization value is 10%
(or 100Mbps) of the total link capacity (or Line Rate).
Number of bytes
Pause Frames:
Total number of transmitted and received ethernet pause flow-control frames.
BERT Results - Summary
Go back to top Go back to TOC
13.3.2.2 Errors
Errors tab:
The following errors (Current and Total) are displayed.
Bits:
Indicates errors related to test pattern (Bit Error or LSS [Pattern Loss])
BER:
Bit Error Ratio
Symbol:
Declared when an invalid code-group in the transmission code is detected
FCS/CRC:
Number of received frames with an invalid FCS
FCS/CRC Rate
IP Checksum
(Layer 3 only)
Jabber frames:
Number of received frames larger than 1518 bytes containing an invalid FCS
Runt frames:
Number of received frames smaller than 64 bytes containing an invalid FCS
BERT Results - Errors
RXT-3900 e-Manual D07-00-111P Rev A00