VARI
❋
LITE - VL2200 S
ERIES
S
POT
L
UMINAIRE
U
SER
’
S
M
ANUAL
2 4
22 - May- 0 1
0 2 . 9 6 7 3 . 0 0 0 1 A
Addressing
Program Starting Address
The address setting for DMX console or Virtuoso console controlled systems is
entered using the Menu Display. (Refer to
Chapter 4: Menu System
for detailed
instructions.)
The luminaire retains the DMX and Virtuoso addresses that are stored even if power is
removed.
Note:
Refer to your console operating instructions for specific information regarding
its addressing requirements.
Program a DMX or Virtuoso starting address:
1. Press [Menu].
2. Press [Up] / [Down] arrows until
ADDR
(Address) appears. Press [Enter].
3. Press [Up] / [Down] arrows to access
DMX
(DMX console control) or
VIRT
(Virtuoso console control). Press [Enter].
4. Press [Up] / [Down] arrows to enter starting address.
5. Press [Enter] to set.
Program Starting Address Without Calibrating the
Luminaire
It is possible to bypass the calibration sequence and go directly to the Menu Display
programming in order to pre-program an address setting.
Program starting address without calibrating luminaire:
•
While powering up luminaire, press and hold [Menu]. Program address as in
“Program Starting Address”
above.
Note:
The luminaire will require a reset to restore control.
