Valor Fires 954, Installer And Owner Manual

Page: 58 / 64

CERAMIC FUEL EFFECT FITTING
The installer and owner guide for the ceramic fuel effect is separate from this guide.
The installer may have attached it to this guide or placed it inside. It is important that
the installer and owner guide for the ceramic fuel effect is followed correctly. If
replacing the ceramic fuel effect, where a new guide is supplied, follow the installer
and owner guide supplied with the replacement fuel effect.
Keep the replacement installer and owner guide with this owner guide for future
reference.
MAINTENANCE
Battery replacement.
The igniter unit uses a 9V PP3 battery. To gain access to the battery:
Luxor and Opulent models - To replace the battery remove the firefront / lower
fascia section.
Chic model - To remove the lower hanging trim firmly hold the sides of the trim and
gently pull forward. It is held in place with magnets.
Envy, Heritage Westminster and Willoughby models - The lower hanging trim is
hooked in place. To remove, hold it firmly and lift upward and forward.
Brooklyn and Moonlight models - To access the
battery the fascia must be removed. To do this hold
the lower sides of the fascia, pull gently forward to
release the fascia from the retaining magnets and lift
the fascia clear of the upper hanging brackets.
1. Remove and discard the battery from the ignition
block located below the burner tray at the left side.
2. Fit the replacement battery to the ignition block
(See figure 5). The positive (+ ve) and negative (-
ve) terminal positions are clearly marked on the
igniter block.
3. Replace the firefront / lower fascia /fascia.
Chic model -The lower section of the fascia has
two tabs. Locate these into the slots in the
fascia (See figure 6). It may be necessary to re-
position the magnets that secure the lower
section.
Envy model - Locate the lower section of the
fascia onto the tabs as shown in figure 7.
Page 58
©
Baxi Heating U.K. Limited 2010.
OWNER GUIDE
Figure 6. Fitting the lower section
to the Chic and Envy fascia
Figure 5. Fitting the battery