Valor Fires 954, Installer And Owner Manual

Page: 28 / 64

supplied . Screw the eyebolts into the plugs. Make sure
that the bolts are secure.
4. Place the hotbox unit close to the fireplace but allow
sufficient access into the fireplace opening so that the
cables can be threaded through the eyebolts and returned
through the side of the hotbox. If a concealed connection is
being used, insert the hotbox into the fireplace feeding the
supply pipe through the pierced hole in the rear grommet.
5. The rear of the hotbox has a slot and hole each side of
the outlet opening. Assemble one end of the cable to the
top of the fire by passing it through the small round hole
and locking by positioning the cable in the adjacent slot
(See figure 17). Give the cables a pull so that they
grip.
6. Thread the cables through the eyebolts. Return the
cables through the holes near the bottom of the hotbox
side panels (See figure 18).
7. Place the hotbox fully back into the fireplace
opening so that it is sealed against the fireplace front
surround.
8. Fit a cable retainer over the bottom end of each
cable.
9. Pull each cable taut. Push the cable retainers hard
up against the side panels. The end of the cable
adjuster will pass into the hole. Tighten the screws in
the retainers so that they clamp the cables in position.
Apply tension to the cables by turning the hexagonal
adjusters by hand (See figure 19).
10. Inspect the installation of the hotbox against the fireplace surround. If the hotbox
is aligned squarely and the sealing is satisfactory, fully tighten the cable retainers.
11. If the hotbox is not correctly aligned, release the tension on the cables by
slackening the screws and turning the hexagonal adjusters fully anticlockwise. The
hotbox should then automatically realign itself. Pull each cable taut again and push
the cable retainers back against the side panels. Again, tighten the screws in the
retainers and apply tension to the cables by turning the hexagonal adjusters
clockwise as far as possible.
12. Do not cut off any excess cable, instead coil up the cable so that they are
available to allow easy removal and refitting of the appliance during subsequent
service calls.
Page 28
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Figure 18. Cable route
Figure 17. Upper cable
retention