Valor Fires 954, Installer And Owner Manual

Page: 34 / 64

Page 34
11.5 Fitting the ‘Willoughby’ fascia.
1. Attach the slider knob assembly to the slider using
two M4 x 10mm screws supplied (See figure 26).
2. The front face of the hotbox has 9 magnets that
may have moved in transit. Position the magnets as in
figure 28.
3. Fit the fascia to the appliance by locating the top to
the upper hanging brackets (See figure 25), then
attaching it to the body of the appliance using the two
screws supplied (See figure 27).
4. The fascia is supplied with three decorative trims.
Where fitted, remove any protective film from the
surface of the trims. Locate the trims as in figure 28.
Locate the side trims first.
5. Connect the control linkage to the control pivot
plate using the shouldered screw and using a
screwdriver (NOT finger tight only) (See figure 29).
6. Supplied with the fire is a self adhesive control
position label. Peel the backing from the label and
place as in figure 30.
7. Locate the lower firefront.
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Figure 28. Fascia trims
Figure 27. Fascia securing
screws (fascia may differ
from that shown).
Figure 26. Slider control knob