Valor Fires 954, Installer And Owner Manual

Page: 33 / 64

11.3 Assembling the ‘Heritage’ fascia.
(See figure 24).
Step 1. Lay the fascia face
down on a flat surface.
Step 2. Unscrew and
remove the lower brackets.
Step 3. Locate the lower
right hand bracket and right
hand side trim onto the
fascia and secure with 3 off
M5 x 10mm screws
supplied.
Step 4. Locate the lower
left hand bracket onto the
fascia and secure through
the lower hole with 1 off
M5 x 10mm screw
supplied.
Step 5. Locate the left
hand side trim and slider
control and secure through
with 2 off countersunk M4 x
10mm screw supplied.
11.4 Fitting the ‘Luxor’, ‘Opulent’, ‘Heritage’ and ‘Westminster’ fascia.
1. Fit the fascia to the appliance by locating the
top to the upper hanging brackets (See figure
25), then attaching it to the body of the
appliance using the two screws supplied (See
figure 27).
2. Connect the control linkage to the control
pivot plate using the shouldered screw and
using a screwdriver (NOT finger tight only) (See
figure 29).
3. ‘Luxor’ and ‘Opulent’ models only - Fit the
decorative knob to the firefront / ash pan and
place centrally beneath the fascia.
4. Supplied with the fire is a self adhesive
control position label. Peel the backing from the
label and place as in figure 30.
5. Locate the lower firefront.
Page 33
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Figure 25. Fitting the fascia (Shown
with Chic fascia)
Figure 24. Heritage fascia.