Valor Fires 954, Installer And Owner Manual

Page: 32 / 64

11. FITTING THE FASCIA
Important: Before continuing with the installation of the fascia complete the
information in the warranty and service section of the Owner Guide (See last
pages of the OWNER guide).
11.1 Assembling the ‘Luxor’ and ‘Opulent’ fascia.
(See figure 23).
Step 1. Lay the fascia
face down on a flat
surface.
Step 2. Unscrew and
remove the side infill
panel. Discard the side
panel and screws.
Step 3. Locate the lower
right hand bracket and
right hand side trim onto
the fascia and secure
with 3 off M5 x 10mm
screws supplied.
Step 4. Locate the lower
left hand bracket onto the
fascia and secure
through the lower hole
with 1 off M5 x 10mm
screw supplied.
Step 5. Locate the left
hand side trim and slider
control and secure with 2
off countersunk M4 x
10mm screw supplied.
11.2 Assembling the ‘Westminster’ fascia.
(See steps 3-5 in figure 23).
Step 1. Lay the fascia face down on a flat surface.
Step 2. Locate the lower right hand bracket and right hand side trim onto the fascia
and secure with 3 off M5 x 10mm screws supplied (Point 3 in fig. 23).
Step 3. Locate the lower left hand bracket onto the fascia and secure through the
lower hole with 1 off M5 x 10mm screw supplied (Point 4 in fig. 23).
Step 4. Locate the left hand side trim and slider control and secure with 2 off
countersunk M4 x 10mm screw supplied (Point 5 in fig. 23).
Page 32
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Figure 23. Luxor and Opulent fascia. (Fascia and bracket
design may differ from those shown)