Valor Fires 954, Installer And Owner Manual

Page: 25 / 64

7. GAS SUPPLY CONNECTION
A nut and olive are provided for an 8mm pipe inlet connection to the ‘T’ connector at
the bottom front of the appliance. The ‘T’ connector can be rotated to allow a
connection from any direction. The ‘T’ connector includes a valve for isolating the gas
supply and a pressure test point.
The supply pipe must be rigid material. Flexible pipe must not be used.
Concealed supply pipe connection.
If a concealed connection from inside the fireplace is required then , before the
appliance is fitted into the fireplace it will be necessary to extend the supply line so
that it will project through the hole in the back of the hotbox and run to the ‘T’
connector at the front. The pipe run from the supply line up to the rear opening in the
hotbox must be kept away from the area which will be taken by the hotbox when it is
installed. Note that the centre of the appliance inlet ‘T’ connector is 25mm above the
fireplace floor.
The inlet ‘T’ connector should be fitted to the supply pipe at this stage.
8. PREPARING APPLIANCE FOR INSTALLATION
8.1 Appliance preparation.
1. Remove any transit tape and packing and inspect for any evidence of mishandling
which might affect the performance. Each unit is flame tested before it leaves the
factory and as a result there may be slight discolouration around the burner ports.
2. Detach the burner unit from the hotbox by removing two screws (See figure 11). Lift
the burner unit clear.
I
MPORTANT: Before continuing with the installation of this gas fire the aeration
setting on the burner must be checked. The aeration is factory set for use with
a ceramic pebble fuel effect (See section 16.1).
3. It is important that the grommet supplied in the loose parts pack is fitted to
the hole in the rear of the hotbox.
4. There is a length of self adhesive
foam seal supplied with the fire. This will
need to be fitted to the outer rear edges
of the side and top flanges of the
hotbox. Cut the foam seal to the
required length. Be careful not to stretch
the seal when measuring. Remove the
protective backing from the foam seal
and fit this to the rear of the top flange
(See figure 12).
Page 25
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Figure 11. Burner attachment points (Burner
detail may differ from that shown)