Valor Fires 954, Installer And Owner Manual

Page: 24 / 64

6. IGNITION CHECK
Before attempting to install, it is worth checking that the electronic ignition system
performs satisfactorily.
Fit the battery to the ignition block located below the burner tray at the left side (See
figure 8). The positive (+ ve) and negative (- ve) terminals are clearly shown on the
ignition block body.
Chic, Envy, Heritage, Luxor, Opulent,
Westminster Slimline & Willoughby models.

Depress the control pivot plate as far as it will
go. This should close the ignition circuit. Sparks
should be seen tracking from the electrode pin to
the pilot tip (See figure 9).
Brooklyn & Moonlight models.

Attach the slider knob assembly to the slider using two M4 x 10mm screws
supplied (See figure 10).

Press down the control knob as far as it
will go. This should close the ignition circuit.
Sparks should be seen tracking from the
electrode pin to the pilot tip
.
If there are no
sparks make the following checks:
1. Check condition of battery and that it is
correctly fitted.
2. If the above is satisfactory, check the
ignition circuit and components (See the
servicing section in this manual).
Page 24
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Figure 9. Slider control
Figure 8. Fitting the battery
Figure 10. Attaching the slider knob
assembly.