36
Installing the Siren Unit
Figure 11
1. Drill mounting holes (7mm diameter,
25mm minimum in depth) into the
chosen wall.
2. If a masonry wall, use the green star
plugs. Press each one into the 4
main mounting holes.
3. Make a
12mm
hole and feed the
10m of low voltage power cable
through the wall and up into the
ceiling for power.
4. Screw the top 2 screws half way in.
5. Place the unit to support itself from
the top 2 screws through the key
shape holes at the top of the main
control unit
6. Screw in and tighten the bottom two
mounting screws then tighten the top
two screws.
7. Now run the 10m of low voltage
cable through the roof to the closest
power point.
8. Plug the power adapter into your
power point, connect the 10m cable,
and then turn the power point on.
9. Now turn the keyswitch on the
outdoor siren to the ON position
(clockwise).
Note:
If for any reason your external siren does not beep when you arm &
disarm your Valet Digital, simply turn off the External Siren Keyswitch, wait for
10 seconds and then turn back on again. Now immediately (within 3 seconds)
arm the system using your remote control. You should now hear 1 beep from
the external siren.
Figure 10
Plug from power adapter Socket from 10m of
connected to powerpoint cable from the siren
