Installing the Camera in a Hard Ceiling
You will need mounting kit 998-2225-152 to install the camera in a gypsum board (drywall) or wood ceiling.
This mounting kit is not included with the camera.
The camera is raised into place through a square hole in the ceiling, and attached from below using two
mounting plates. A large trim ring conceals the portion of the camera enclosure outside the bezel and the
camera mounting plates.
Preparing the Hard Ceiling
Follow these steps to mount the camera in a gypsum board or other non-suspended ceiling using Hard
Ceiling Mounting Kit 998-2225-152.
Note
All above-ceiling work must conform to local building codes and should be performed by qualified
personnel.
1. Determine the exact alignment of the camera with respect to the subject.
The camera face with the connector must point in the same direction as the
top of the document or other camera subject.
Note
The image cannot be rotated. Ensure that the camera is aligned precisely.
2. Trace a square, 8.125 x 8.125 inch (20.7 x 20.7 cm), for the camera opening.
3. Cut the camera opening.
11
Integrator's Complete Guide to the DocCAM 20 HDBT Ceiling-Mounted Document Camera
