V-TEK Royce DE35-ST, User Manual

Page: 53 / 146

52 D292469I
Inspections Options Submenu
This Sub Menu allows you to select or de-select any Inspection options that may
be on your machine.
Inspect Die Underside- Selected/Not Selected:
Selecting this mode allows the operator to view and inspect the underside of
the die. This will set up the machine so that the pickup arm stops over the
optional underside inspection camera, before placing the die. The underside
inspection option must be installed to view the underside of the die.
Inspect Die Facet - Selected/Not Selected:
Selecting this mode allows the operator to view and inspect the Edges of the
die. This will set up the machine so that the pickup arm stops at the optional
facet inspection position, before placing the die. The facet inspection option
must be installed to view the facet of the die.
Die Pickup: Non Surface Pickup / Surface Pickup
Surface Pickup
This will set up the machine for pick up tips that touch the top of the die to
pick them. Vacuum is applied through the pickup tip to hold the die.
Non-Surface Contact Pickup
This will set up the machine for the non-surface contact grippers (NSC) to
pick the die. The fingers of the grippers will lift the die from the sides, or
bottom edges to pick them. You must have the non-surface contact
machine, with the NSC pick up head installed to take advantage of this
feature. An NSC machine can be converted for Surface Pickup but a Surface
contact machine cannot be converted for NSC operation.
Die Inverter: Selected/Not Selected
Die Inverter is selectable on systems that have a DI-26837. This device will allow
the user to invert die before placing them into Waffle Pack or Gel-paks.
This device can be setup using the procedures listed in THE DIE INVERTER
SYSTEM.