126
D292469I
ii.
Holding top of the piston, replace the hex/locking screw
and tighten.
iii.
Verify the spring is seated at edge of the hex nut,
perpendicular to the shaft axis. The edge of the spring
should not go beyond the plane edge of the hex screw.
Note: If the spring cannot be set flush to plane edge of
hex screw, replace the spring [PN 2092].
iv.
Align the piston with the flange so that the screw holes
are aligned to notches in piston.
b.
Plunger style
eject heads: Insert piston into eject head
body, aligning springs to alloy set screws.
Summary of Contents for Royce DE35-ST
