V-TEK Royce DE35-ST, User Manual, Page: 14 / 146

DE35-ST Operating Instructions
D292469I 13
Setup & Start-Up
Connections & Setup
1. Locate the Foot Switch and plug into the appropriate connector on the Rear
Panel.
2. Remove the Transit Screw holding the X-Y Stage in position. This is located at the
front right corner of the X-Y Stage and has a red plastic cap.
3. Install the Target Camera Mounting Bracket with Lens assembly, using (2) ¼ x 20
Socket Head Cap Screws provided. (Requires a 3/16 Allen wrench).
a. Screw the Camera onto the top of the Lens Assembly until it stops and is
snug, but not tight.
NOTE: Be careful, the screw threads are fine and are easily damaged.
b. The Camera orientation is set at the factory so that a non-inverted image
appears on the monitor.
4. Install an Eject Head into the Eject Actuator (see directions on the following
page).
a. If you have more than one type of Eject Head a single needle Eject Head
is preferable for alignment purposes.
b. Verify air and vacuum are connected to the Actuator and the Eject Head.
5. Connect the Power Supply (1).
6. Connect the Display Port to HDMI cable between the PC and monitor (2).
7. Attach the COM cable from the Mainframe’s COM2 port to the USB to Serial
convertor’s DB9. Plug the USB side into the PC’s USB (3).
8. Connect all USB devices based on Type A or B system configurations:
a. The system possesses a single camera
i. Connect the camera to USB (4)
2
1
5
6
3
4
Figure 1 - Back panel of PC