V-TEK Royce DE35-ST, User Manual

Page: 43 / 146

42 D292469I
Calibrating Waffle Packs
The waffle pack dimensions are loaded when the part number is entered. The
dimensions are rough, and to insure proper placement accuracy the waffle packs should
be calibrated each time a new part number is used . The same applies when the waffle
pack is filled and fresh packs are installed.
For better accuracy in calibration you can start in single step and pick a die, move over
to the place position with the die on the tip press
CALIBRATE TRAYS
. This will allow you
to adjust pockets to place the die into the pocket.
1. On the keyboard, press the
OUTPUT SIZES
key.
2. On the LCD Display, scroll down to
CALIBRATE TRAYS
, then press the
YES
key.
The Pickup Tip will move to the first pocket of the first pack and move down
to place height.
3. Use the DOWN key to lower the tip into the pocket to make it easier to see
where the tip is in the pocket.
4. Use the ARROW keys to align the tip in the center of the pocket. Use the
COARSE/FINE keys to toggle between large steps and small steps. Use the
UP/DOWN buttons to adjust the height of the pick-up tip. In the X direction a
small step is 2 mils. In the Y direction a small step is 1 mil. A large step for
both is 10 small steps.
5. When the first pocket is aligned, press the + key to move the pickup to the
last pocket of the pack and repeat step 4.
6. Repeat steps 4 and 5 until the first and last pocket of all packs are calibrated.
Press the YES key when the last pack is calibrated to return to the menu.
Press NO , then YES to return to normal operation.
Note: All trays must be calibrated even if they will not be used. If any trays are
not properly adjusted, then the calibration of the other trays will be off.