UTT Technologies
Chapter 5 Network
http://www.uttglobal.com
Page
4646
Figure 5-15 Connection Detection Settings
Interface:
It indicates the name of the WAN interface. It is non-editable.
Detection Interval:
It specifies the time interval at which the Gigabit Router
periodically sends detection packets, one packet at a time. It must be between 1 and
60 seconds, or 0. The default value is 0, which means that connection detection is
disabled on the Internet connection.
Retry Times:
It specifies the number of retries per detection period. The default value
is 3.
Detection Target IP:
It specifies the IP address of a detection target device. The
Gigabit Router will monitor the Internet connection by sending the detection packets
to the detection target IP address.
Bandwidth:
It specifies the Internet connection’s bandwidth, which is provided by
your ISP.
Start Internal IP
and
End Internal IP:
They specify a range of internal IP addresses.
The local computers within the specified range will preferentially use the Internet
connection. Refer to
Section 5.2.1.1 Internet Connection Detection Mechanism
for more information.
Save:
Click to save your changes.
Cancel:
Click to revert to the last saved settings.
Back:
Click to go back to the
Load Balancing List
page.
Note
The
Detection Target IP
,
Detection Interval
, and
Retry Times
are connection
detection related parameters. Please refer to
Section 5.2.1.1 Internet Connection
Detection
Mechanism
for
more
information.
