http://www.uttglobal.com
Page 11
UTT Technologies
Chapter 2 Hardware Installation
/
www.argo-contar.com
Chapter 2 Hardware Installation
2.1 Physical Characteristics
2.1.1 Front Panel
As shown in Figure 2-1, the LEDs are located on the front panel of the Gigabit Router. The
LEDs indicate the status of the system and each port. Table 2-1 describes these LEDs.
The front panel also offers a Reset button, a USB port and 5 ports. Table 2-2 describes
these ports.
Figure 2-1 Front Panel of the Gigabit Router
1. LEDs
LED
Full Name
State
Description
PWR
Power LED
On
The Gigabit Router is powered on.
Off
The Gigabit Router is powered off.
SYS
System LED
Blinking
The system is operating properly.
On
The system is not operating properly.
Off
The system is not operating properly.
USB 1
Built-in USB
Status LED
On
There’s 1 built-in USB Flash Memory connected to the
system.
