UTC Fire and Security M3000, Installation Manual

Page: 154 / 174

M5 controller
Installation Manual
144
CE (European) and FCC compliance
As of January 1, 1996, all new European Union member installations MUST be CE compliant.
To make the M3000 installation CE and FCC compliant, the following conditions must be met:
• All cables connected to the M3000 must be shielded with shield terminated as shown in Figure 73 .
• The M3000 enclosure must be connected to the nearest earth ground. See Figure 74 on page 145.
Use #8-32 SEMS screw and #8 flat washer provided to secure the ground lug.
• The Power/Communications board must be in the far right slot of the M3000 card cage and grounded
with a factory-installed braided wire as shown in
Figure 75 on page 145.
• The CPU board must be in the second slot from the right of the M3000 card cage and grounded with a
factory-installed braided wire as shown in
Figure 75 on page 145.
• Prior to connecting the network cable to connector J1, loop the cable through the Ferrite provided and
wrap cable around the Ferrite four times as shown in
Figure 76 on page 146.
Note: Ferrite must be installed inside of the enclosure.
Figure 73.Typical installation using shielded cable/drain wire - outside and inside the enclosure
Outside the enclosure
Inside the enclosure