The SureCross
™
DX70 wireless kits include build a point-to-point network using two devices and configured I/O
Features
The SureCross
™
DX70 wireless series consists of a radio frequency network built around
two devices and configured I/O.
• Wireless industrial I/O system with discrete (sourcing or sinking) inputs and outputs,
analog inputs and outputs, and a link loss output that may be selected or deselected
to be one of the four outputs
• DIP switches for user configuration
• 10 to 30V dc power input
• Site Survey analyzes the network’s signal strength and reliability
• Frequency Hopping Spread Spectrum (FHSS) technology and Time Division Multiple
Access (TDMA) control architecture combine to ensure reliable data delivery within
the unlicensed Industrial, Scientific, and Medical (ISM) band
• Transceivers provide bidirectional communication between the Gateway and Node, in-
cluding fully acknowledged data transmission
• Lost RF links are detected and relevant outputs set to user-defined conditions
• External or internal antenna
For additional information, the most recent version of all documentation, and a complete
list of accessories, refer to Banner Engineering's website,
Models
When ordering the SureCross DX70 device, order the kits listed below. The kits include the Gateway, Node, mounting hardware, access
hardware, antennas, and cables. Each kit's devices ship from the factory bound and with the inputs and outputs mapped as shown in the
I/O mapping tables.
Kit Models
Frequency
Inputs and Outputs
DX70K9M6EM1
900 MHz
Inputs: Four selectable discrete, two 0-20 mA analog
Outputs: Four sourcing discrete, two 0-20 mA analog
DX70K2M6EM1
2.4 GHz
DX70K9M6ED1
900 MHz
Inputs: Eight selectable discrete on the Node, four selectable discrete on the
Gateway
Outputs: Four sourcing discrete on the Node, eight sourcing discrete on the
Gateway
DX70K2M6ED1
2.4 GHz
Internal antenna models are also available, but are not UL Listed. For more information, contact your local Banner Engineering Corp.
representative.
WARNING: Not To Be Used for Personnel Protection
Never use this product as a sensing device for personnel protection. Doing so could lead to serious injury
or death. This product does NOT include the self-checking redundant circuitry necessary to allow its use in
personnel safety applications. A sensor failure or malfunction can cause either an energized or de-ener-
gized sensor output condition.
SureCross DX70 Wireless Point-to-Point Kits
P/N 133214 rev. H
6/16/2011
0 133214
8
