UTC Fire and Security M3000, Installation Manual

Page: 56 / 174

M3000
Installation Manual
46
Introduction
The M3000 controller supports four types of reader processing boards: 2RP, 2SRP, and the 8RP. Only one type
can be used at one time, for a maximum of:
• Four 2RP boards (for support of up to eight readers),
• Four 2SRP boards (for support of up to eight supervised readers), or
• Two 8RP boards (for support of up to 16 readers).
2RP board
Introduction
Each 2RP reader board provides two reader ports, four unsupervised DIs (two door alarm, two REX inputs),
two reader LED outputs, two door strike DO relays, two auxiliary DO relays, and two alarm shunt relays used
to shunt out external alarm inputs. Please note the following:
• Each 2RP board is limited to only one type of reader technology: Wiegand, Strobed, F/2F, and
Supervised F/2F. In addition, both readers connected to the board must use the same voltage.
• In Supervised F/2F mode, the exit request and door alarm contact wiring is terminated at the reader.
• Each reader, DI point, Aux DO, and Exit DI on a 2RP board is addressed differently, depending on the
host system you are using. Refer to the
Table 18 and Table 19 .
• If alarm points are not available on the reader, use alarm points on the controller.
Device addressing
Picture Perfect
Table 18. 2RP device addressing - Picture Perfect
Board 1 Board 2 Board 3 Board 4
Readers 0 and 1 0 and 1 0 and 1 0 and 1
Door DIs 0 and 1 0 and 1 0 and 1 0 and 1
Exit DIs 8 and 9 8 and 9 8 and 9 8 and 9
Door DOs 0 and 1 0 and 1 0 and 1 0 and 1
Auxiliary/shunt DOs 8 and 9 8 and 9 8 and 9 8 and 9