UTC Fire and Security M3000, Installation Manual, Page: 110 / 174

M3000
Installation Manual
100
6. If this computer is set for:
• DHCP, then the Obtain an IP address automatically field is already selected. Select Use the
following IP address .
• Static, write down the IP address and Subnet number. You will need to reset your computer back to
these numbers after the controller configuration is complete.
7. Enter the IP address
192.168.6.5
, or a similar valid IP address (
192.168.6. x
where
x
is any
number between 1 and 254 except 6).
8. Change the subnet mask to
255.255.255.0
.
Note: You do not need to change the gateway.
9. Click OK until all open windows are closed.
10. Connect the Cat-5 crossover cable from the Ethernet port on your laptop or computer directly to the
controller Ethernet port (no hub or switch).
11. If your controller is not yet powered up, do so now.
12. Open an Internet browser window on your computer.
13. In the browser’s Address field, enter the default static IP address of the controller:
192.168.6.6
14. When the Integrated Configuration Tool starts, enter your username and password.
Note: The default values for username and password are
install
,
install
. We recommend that you
change these values for added security, as described on page 117.
Initial configuration: Windows XP
1. Click Start , Control Panel , then Network Connections .
2. Right-click on Local Area Connection. If the first option in the drop-down list box is:
• Disable , then the connection is enabled. Go to step 3 .
• Enable , then select it to enable the connection. Return to step 1 .
3. Select Properties from the drop-down list.
4. In the This connection uses the following items: section, select Internet Protocol TCP/IP .
5. Select Properties .
6. If this computer is set for:
• DHCP, then the Obtain an IP address automatically field is already selected. Select Use the
following IP address .
• Static, write down the IP address and Subnet number. You will need to reset your computer back to
these numbers once the controller configuration is complete.
7. Enter the IP address
192.168.6.5
, or a similar valid IP address (
192.168.6. x
where
x
is any
number between 1 and 254 except 6).
8. Change the subnet to
255.255.255.0
.
Note: You do not need to change the gateway.
9. Click OK until all open windows are closed.