Fig. 53
Mounting the intermediate gear
Fig. 52
Mounting the kick-starter shaft
- Fit the kick-starter shaft with gears into the cover bringing the gears in mesh (Fig. 52);
- Set the bracket with intermediate gear;
- Having the reverse gear quadrant pressed out insert the bracket shaft into the cover hole
(Fig. 53)
- Set the reverse gear shift fork and insert its lugs into coupling slots of the coupling gear, bolt it
and lock with the tab washer.
- Insert the spring of the kick-starter shaft (Fig. 54)
Fig. 54
Mounting the kick-starter gear.
Reassembly of Cover with Gear Case
The tools required for reassembly are: mandrel 346-298 for pressing the gear case on the cover
with shafts, and spanner 36Õ41.
For reassembly:
- Install the cover with shafts, with the joint face upwards;
- Coat the joint faces with Locktite
- Set the shims into the blind hole in the crankcase and grease them (Fig. 55);
- Set the pin of mandrel 346-298 in the clutch shaft seal;
- Place the gear case on the clutch shaft bearing, the main shaft on the fork shaft and bracket
shaft aligning the cylindrical pin with a bracket slot;
- Align the slot of the gear change foot pedal with the crank pin; by striking slightly with an
aluminum hammer fit the gear
case on the bearings, then press the gear case on the press making
use of mandrel 346-298;
Fig. 55
Setting the shims
Fig. 56
Setting the gear case
61
Summary of Contents for 750cc Series
Page 1: ...Repair Manual 750cc All Models www imz ural com ...
Page 2: ......
Page 71: ...1 2 3 4 5 6 7 8 Fig 66 Final drive 71 ...
Page 98: ...Fig 11 iring Diagram 9 W 98 ...
