[
Troubleshooting
]
1
Troubleshooting
Continued
Symptom
Solution
I get an
Out of Range
message
even when I’m close to the
Sirius Conductor Tuner
Go through SIRIUS setup and delete the Sirius Conduc-
tor Tuner. Then pair the Sirius Conductor Tuner to the
wireless controller again. Refer to the section
Pairing
Your Wireless Controller With Your Sirius Conductor
Tuner
on page 20.
I can’t get all the remote control
functions working properly
for my device (TV, Receiver,
Cable Box, etc.) when using the
wireless controller
Some manufacturer’s codes enable only partial func-
tions. Try going through the remaining manufacturer’s
codes in the list to find one that works better. If you
can’t find any, then use the learning function to learn
the missing functions from the device’s remote control.
(Refer to the
Learn Feature
section on page
41
.)
No display at all times
Replace batteries with four new AAA alkaline batteries.
No display when programming
Display has turned off due to inactivity. Start program-
ming again and do not pause while performing instruc-
tions.
During programming, the LED
displays a long flash.
An invalid entry has occurred. Check the keys to be
pressed and start programming again.
How do I stop programming?
Press
SET
once to back up one step in programming.
Press and hold
SET
to exit programming completely.
Changing channels does not
work properly
If the original remote control required pressing
ENTER
to change channels, then press
ENTER
on the wireless
controller after entering channel numbers.
No remote control of volume
Refer to the section
Lock Volume Feature
on page
44
to lock and unlock volume control.
Cannot program my combo
device code
Make sure have selected the correct device key for your
combo code.
