[
Sirius Conductor Tuner Operation
]
Selecting a Preset
To select a channel you have saved as a preset:
Select the band
by pressing and releasing
BAND
until the desired band is displayed in
the upper right hand corner of the display (A, B, or C).
Press and release the numeric key in which the preset is stored, for example, 1.
After 1.5 seconds the preset channel is tuned.
You can also use the
FAV
key to browse though the saved presets.
Multi-Radio Control
You can control up to two SIRIUS radios with your wireless controller, the Sirius Conductor
Tuner (model SC-H1W) and the SiriusConnect Home (model SC-H1). To add a second radio,
connect it to your Sirius Conductor Tuner radio using the DIN cable which was included with
the SiriusConnect Home.
Note:
After you connect the SiriusConnect Home, make sure to press the
RESET
button
on the Sirius Conductor Tuner. This enables the second radio. Then follow the installation
instructions for the SiriusConnect Home to activate the radio.
Note: The SiriusConnect Home must use the AC Power Adapter which was provided
with the radio.
To select the second SIRIUS radio, press and hold
SIRIUS
for 1.5 seconds, or press
SWAP
.
To highlight a radio (either
1
or
2
), press
CH +
,
CH –
,
CURSOR UP
( ), or
CURSOR
DOWN
( ).
Press
SELECT
or
DIRECT
to select the highlighted SIRIUS radio.
When both SIRIUS radios have been correctly set up, the default display shows a superscript-
ed number to indicate which radio is currently being displayed. Figure 5 shows information
from SIRIUS radio 1 being displayed.
1.
2.
3.
1.
2.
3.
