[
Wireless Controller Operation
]
network Reset
Performing a network reset will delete
all
nodes which had been added to the wireless con-
troller, including your Sirius Conductor Tuner. If you only want to remove a specific node from
your network, refer to the previous section
Deleting a Node
.
To perform a network reset:
Press and hold
SET
until the LCD displays
Initial Setup
.
Press
Scroll Left
( ) or
Scroll Right
( ) to go to
SIRIUS SETUP
. Press
OK
.
The LCD displays
NODES
. Press
Scroll Left
( ) or
Scroll Right
( ) to go to
NETWORK
.
Press
OK
.
The LCD displays
NETWORK RESET
. Press
OK
.
The LCD displays
WAITING
, indicating that a network reset is in progress.
The LCD displays
Successful
when the network has been reset.
Press and hold
SET
to exit the menu.
Note:
Nodes which have been removed from your network by performing a network reset still
retain the Home ID information from the wireless controller. If you need to remove the Home
ID information from a node, delete the node as described in the previous section,
Deleting a
Node
on page 35, rather than performing a network reset.
Adding, Deleting, and Replacing Devices
You can control up to 12 devices with your wireless controller. These would be devices which
are not Z-Wave compatible (as described in the previous section) but are commonly found
in home entertainment systems, such as receivers, TVs, satellite boxes, etc., and which have
their own remote controls.
The following table lists the types of devices you can control with your wireless controller.
While adding, deleting, or replacing a device, the long name for the device is shown on the
LCD screen. At all other times, the LCD displays the short name for the device.
device Types
long name
Short name
RECEIVER
RCV
1.
2.
3.
4.
5.
6.
7.
