IV
CAUTION
●
Tighten the screws for the signal input/output terminals at the specified torque.
If they are loose, shorts, fire or malfunctions may occur.
Tightening torque: 0.5N•m
●
For sensors, external inputs/outputs and options, use shielded cables.
●
The temporary overvoltage applied to the power should not exceed 1500V.
●
For turning on/off the power, be sure to keep intervals of 5 seconds or more.
●
After power-on, make sure to warm up the F701-C for at least 30 minutes or more before use.
●
If the F701-C is not used by the specified method, its protective performance may be
impaired.
●
Maintenance
- When performing maintenance, disconnect the power.
- Do not wipe with a wet rag, or with benzine, thinner, alcohol, etc. Doing so may cause
discoloration or deformation of the F701-C. In the case of heavy contamination, wipe off
the contamination with a cloth after dipping it into a diluted neutral detergent and wringing
it well, and then wipe with a soft, dry cloth.
●
When the F701-C is shipped, spacers made of corrugated cardboard are used as
cushioning materials.
Though it is factory-designed so that shocks can sufficiently be absorbed, breakage may
result if shocks are applied when the spacers are reused for transportation. If you send the
F701-C to us for repair, etc., take adequate measures against shocks by using polyurethane
materials, etc., separately.
●
If you dispose of the product, handle it as industrial waste.
●
Remove the lithium batteries used in the F701-C and make sure to dispose them according
to classification of waste collection.
This sign forewarns the presence of hazards
that could result in personnel injury or property
damage when incorrectly handled.
Caution on wiring
Caution during startup and maintenance
Caution during transportation
Caution during disposal
