UniPOS Repeater IFS7002R
Instruction Manual Page 24
Revision 2/16.11.09 Of 62
• The menu “All” is with two
variants:
When there are no faults (or faults
from the searched type) if you
choose menu “All” on the display
appears:
When there are faults , if you choose
menu „All“ on the dispaly appears fault
informations about all remote panels.
Each message can be displayed in a
few lines – from 1 to 4. It brings out the
following information:
-
Text for the type of the fault
(this information is mandatory).
-
Information for the device
(zone, loop, address if it is an
addressable device).
-
The fire control panel, where
the event has occurred.
-
Text message for the zone –
visualized if the fault condition
is in an addressable fire
detector.
- Text message for the device – visualized if the fault condition is in an addressable device.
Buttons
and
situated in the right panel section scroll the pages up and down – next page
or previous page (if any are available). One page contains two messages for fault condition.
• Menu “LAN objects” gives possibility for choice of connected object, which faults to be
appeared on the display.
Mode: DAY
REP ActInp:0000
11:44:29
Wed 24 Aug 2011
REPEATER IFS7002R
UniPOS
Faults Total: 00000/00002*
Disables Total: 000
Failed Outputs: 0000
Disabled Outputs: 000
List/Faults/Total
0003
0001 Fault in Zone 003 Rem.# 2
Zone: Zone 003
0002 Removed device Rem.# 3
Zone003 Loop001 Addr003
Zone: Zone 003
Addr: Point 1.003
Mode: DAY
REP ActInp: 0000
11:45:23
Wed 24 Aug 2011
REPEATER IFS7002R
UniPOS
List/Faults/Total
NO FAULTS
