UniPOS Repeater IFS7002R
Instruction Manual Page 50
Revision 2/16.11.09 Of 62
To start setting the buttons up,
press button
. Set up is being
performed at two points on the
display and is being checked at
two points. Enter the function to
display the first point of set up:
Must be pressed intersection of the
cross with your stylus.
Similarly proceed with the second,
third and fourth point.
The options for finishing the setting
up are the following:
-
If the check performed at
the third point and the
fourth point is checked and
if it is successful the
function is exited
automatically.
-
In case the performed
check at point three is
unsuccessful, the first
adjustment point is
displayed on the screen.
-
In case the check at point
three is successful, but at
point four is not, then a
screen with text message
for fault condition is
displayed.
The check-up can be interrupted at any stage by pressing button
or
.
17:26:07
Wed 24 Aug 2011
+ Push the Point of intersection
17:48:15
Wed 24 Aug 2011
Operation unsuccessful!
Would you like to run the Operation again?
– confirm
– cancel