UniPOS Repeater IFS7002R
Instruction Manual Page 16
Revision 2/16.11.09 Of 62
• Forced transition to Fire stage II - button
( “Fire stage II”).
• Suppress/enable activation of the outputs for Fire condition
and ( “Outputs”). In
case no suppressed outputs. Button
is active. If outputs are suppressed, will be active
button .
• Exit - buttons
(“Exit”) or
( “Cancel”). If the fire condition is combined with
Information and Control Mode, priority is Fire condition. It always is visualized.
- At Access level 3 and 4, after entering a password:
• All actions by the access level 1 and 2.
8. Fault Condition
8.1. Description
The repeater enters Fault Condition when any of the events below have been registered:
•
Fault in remote panel:
- Fatal system error.
- Fault in a processor programme.
- Fault in the communication with the fire control panel.
- Fault in the real time clock.
- Fault in the external memory.
•
In connected to it a fire control panel:
- Fault in the communication with the fire control panel.
- Fault in the real time clock.
- Fault in the external memory.
- Fault in a fire control panel.
- Fault in a module.
- Fault in a loop – a short circuit or a break.
- Loop not initialized.
- Higher number of devices in the fire alarm loop.
- Fault in a zone – upon detection of fault condition in a device, integrated in the zone.
- Removed device.
Mode DAY REP Act Inp:
0000
09:37:43
Wed 24 Aug 2011
FIRE
ZONES IN FIRE:
3
>
1 Phase1 Zone 001 Building#2
Zone 001
3 Phase1 Zone 002 Building#4
Zone 002
Time Fire Phase 2: 068
Time Fire Phase 2: 080
PASSWORD Outputs
Enter password: _
0
1
2
3
4
5
6
7
8
9
С