Unigas LAMTEC BT3 Series, Manual Of Installation - Use - Maintenance

Page: 53 / 137

5
Manual
Select the MANUAL to :
start and stop the burner manually
adjust the internal burner firing‐rate
If the burner is switched on manually via display, the BT300 no longer responds to the "Burner ON" signal input at
connector X10.2.
It is for this reason that the burner will turn off only with the intervention of the “safety chain”, connector X07, which
will send it in lock‐out!
Settings
Select the SETTINGS path for information on, and to make settings or, the following:
the password
the burner settings (display and settings)
the actuator device settings (display)
the air/fuel control system
the "delete"
the display settings