44
Press EXIT again to quit settings.
The burner runs now in automatic
mode.
In case of troubles, the burner will go
on lock‐out mode and the reason will
be indicated on the display.
Exemple:
H009 – lock‐out code
D1 ‐ diagnostic 1
D2 ‐ diagnostic 2
xxh ‐ operation hours
Check the lock code & press ENTER
to unlock.
If the ignition setting is not good enough (e.g. too much air), the burner cannot start. In that case adjust again the
ignition point see chapter “SETTING THE BURNER CURVE”.
Otherwise make sure that no other reason may cause the ignition failure.
Summary of Contents for LAMTEC BT3 Series
