www.ultratecfx.com
7
Zone Selector
The slave module has a yellow LED indicating ACTIVE FAULT monitoring. This yellow LED is OFF
when a fault is detected and a red channel LED will be on (if it is a short circuit, any device connected
to this channel output will explode immediately).
Slave Power Off
The slave power is required to run the diagnostic routine, therefore when the SLAVE POWER key-
switch is OFF, the system will indicate a FAULT.
Note that when the SLAVE POWER is OFF, all 16 fault indicator (Red) LEDs are ON at all slaves and the
Yellow (Fault Scan) LED is OFF at all slaves.
Slave Power LED
Armed Led
Indicates that the unit is armed at the controller.
Fire Button
Initiates the firing command when depressed.
Indicates that slave power is turned on at the controller
