www.ultratecfx.com
24
Run a Time Code Show with External MIDI Control
At the Home Screen select
*RUN TIME CODE SHOW*
Press >START<
This prompt appears
RECALL A PRE PROGRAMMED SHOW BY
SELECTING ANY OF THE MEMORY LOCATIONS
When one of the >T.C. MEM< keys is pressed the operator will be prompted to confirm the
choice.
Note that the >MEM< keys will not respond in Run Time Code Show.
RUN TIME CODE SHOW # ?
PRESS >ENTER< TO CONFIRM
PRESS >DELETE< TO CANCEL
Pressing >ENTER< will load the selected Show from memory.
The LCD displays READY FOR TIME CODE
Note that recalling a blank memory location will return the END OF MEMORY SHOW message.
Use the ARROW keys to review the cue information before the Time code is received. The cues
will be displayed One cue per line on all 4 lines.
*****VERY IMPORTANT*******
The controller will FIRE the CUE displayed on the TOP LINE of the LCD screen.
The FIRE button will be LIVE if all the safety features are disengaged. Make certain the controller
is in SAFE mode while reviewing cue information.
The external MIDI Show Control system sends MIDI commands to the Controller through a stand-
ard MIDI cable (5-pin DIN).
The controller responds to standard MIDI commands as follows.
MIDI Note On
Note On 1 (lowest MIDI note) will upload Time Code Show Cue#1 to the slaves.
The LCD display will show Cue 1 on the Top Line, followed by the next 3 Cues in numerical order.
Note On 2 (second lowest MIDI note) will upload Cue # 2 etc, with the next three cues in numeri-
cal order.
The Cue numbers are directly mapped to MIDI Note On numbers.
The Airburst controller will respond to the MIDI Note On commands in any order.
