409-10083
AMP 3K and AMP 5K Terminating Machines with the SL Starlite CQM
Rev E
18 of 38
Tyco Electronics Corporation
The machine will exit the Jog (With Guards Disabled) Mode whenever the guards are closed or the power
is turned “off.”
D. Manual Cycling
1. Turn off the machine using the power switch on the back panel.
2. Remove the access cover on the end of the motor (Figure 7).
3. Insert a 6mm wrench into the hex key on the back of the motor.
4. Turn the wrench to rotate the motor and crankshaft.
5. Remove the wrench.
6. Replace the access cover.
To avoid personal injury, always turn off power to the machine when manually cycling. Be sure to remove the hex
wrench and replace the access cover before turning on power to the machine.
4.6. Crimp Height Adjustment
On machines that do not include the precision adjustment feature, the crimp height must be adjusted at the
applicator. Refer to the instructions provided with the applicator to perform this adjustment. Refer to Paragraph
6.3 for procedures to adjust the crimp height using the machine precision adjustment feature.
4.7. End-Feed to Side-Feed / Side-Feed to End-Feed Conversion
When changing from an end–feed applicator to a side–feed applicator (or from a side–feed applicator to an
end–feed applicator), the reel support assembly must be moved to the opposite side of the machine. With the
terminal reel removed, lift and rotate the reel support bar to the opposite side of the machine. Mount the
terminal reel on the reel support and load the terminal strip into the applicator. Remove the metal terminal
lead–in and thumbscrews and move to the opposite side of the machine. Move the machine lubricator bowl to
the opposite side of the machine as required.
Lubricator Bowl Assembly 354550-1 is an optional accessory.
DANGER
NOTE
i
