Tunstall Lifeline 4000, User Manual

Page: 54 / 80

54
Lifeline 4000 Advanced User Guide (B) Copyright © 2000 Tunstall Group Ltd.
configured—see earlier in the chapter) to reset the inactivity stopwatch. However, reliable detection
of activity requires movement sensors.
It is important to remember that the settings you enter into parameter 131 will have no effect
if inactivity monitoring is not enabled using parameter 11 (see the section on Messages and warnings
earlier in this chapter).
Examples
Setting inactivity monitoring to use the stopwatch method with an Inactivity Time of 12 hours
1. Enter local programming mode by holding down the key and then holding down the
# key until the unit beeps. Release the # key first, and then the
key.
2. Enter the parameter—press 1 3 1 .
3. Delete the old value using the C key (display version only).
4. Enter 0 0 0 0 0 0 0 0 0 0 1 2 0 0 and then
press .
5. End local programming by pressing the Cancel key.
Setting inactivity monitoring to use the clock method between 9am and 10pm
1. Enter local programming mode by holding down the key and then holding down the
# key until the unit beeps. Release the # key first, and then the
key.
2. Enter the parameter—press 1 3 1 .
3. Delete the old value using the C key (display version only).
4. Enter 0 1 0 9 0 0 2 2 0 0 0 0 0 0 and then
press .
5. End local programming by pressing the Cancel key.
Setting inactivity monitoring to use both the stopwatch and clock methods between 9am and 10pm,
with an Inactivity Time of 4 hours
1. Enter local programming mode by holding down the key and then holding down the
# key until the unit beeps. Release the # key first, and then the
key.
2. Enter the parameter—press 1 3 1 .
3. Delete the old value using the C key (display version only).
4. Enter 0 2 0 9 0 0 2 2 0 0 0 4 0 0 and then
press .
5. End local programming by pressing the Cancel key.