Tunstall Lifeline 4000, User Manual

Page: 10 / 80

10
Lifeline 4000 Advanced User Guide (B) Copyright © 2000 Tunstall Group Ltd.
Programming a parameter
There are four major steps involved in programming a parameter.
• Enter local programming mode.
• Enter the number of the parameter you wish to alter.
• Delete the present value in the parameter and enter a new value.
• Leave local programming mode.
Enter local programming mode
1. Press and hold , and then also press and
hold
# .
2. Keep holding the keys down until you hear Lifeline
4000 beep (after about two seconds).
3. Release the # key.
4. Then release the key.
5. The words Local Programming will display on the display.
Enter the number of the parameter you wish to alter
6. To enter a parameter press the key. You will then hear another beep and the word
Param will be shown if the Lifeline 4000 has a display.
7. Enter the number of the parameter you wish to change and then press the key. The display
will either show the word Programmed . Lifeline 4000 will beep and then wait for a valid
parameter if you enter an invalid number.
Delete the present value in the parameter and enter a new value
8. Press the C key to delete the present value in the parameter (for the display version only).
9. Enter the new value for the parameter and press the key.
10. Lifeline 4000 will then beep and the display will then show Programmed .
Leave local programming mode
11. You can leave local programming simply by pressing the Cancel key. If you want to program
another parameter then do not press the Cancel key, press the key to enter the number
of the next parameter you wish to program (this takes you back to step 6 in the procedure
above).