DURASWEEP 50&70
OPERATING MANUAL
V01
TSM - Technological Systems by Moro Srl
Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy
Tel. +39.0434.564167
-
Fax +39.0434.954069
www.tsmitaly.com – [email protected]
32
REPLACEMENTS
11.8 Replacing the centre brush:
ALWAYS WEAR GLOVES AND A BREATHING MASK WHEN REPLACING THE CENTRE BRUSH AND ONLY CARRY
OUT THIS MANOEUVRE WITH THE ENGINE AT A STANDSTILL AND COLD.
1.
Remove the bin
Detail A Fig.1
and push the handle to bring the
machine into the position illustrated in
Fig.13
.
2.
Unscrew and remove the two screws
Detail A
and
B Fig. 13
.
3.
Before removing the brush from the machine note the direction of
the bristles (see
Fig.13
).
4.
Remove the worn brush and replace it with a new one.
5.
Replace and tighten the screws
Detail A
and
B Fig. 13
and adjust
the height of the brush (
see paragraph ADJUSTMENTS: CENTRE
BRUSH in the previous pages
).
11.9 Replacing the side brush:
1.
Remove the bin
Detail A Fig.1
and tilt the machine as shown in
Fig.13
.
2.
Unscrew and remove the three screws
Detail C
that hold the side
brush
Detail 1
in place.
3.
Remove the brush belt from the plastic pulley.
4.
Remove the side brush using a screwdriver for leverage in the groove on the pulley race (see
Fig.14
)
5.
Assemble a new brush and secure it by carrying out the above operations in reverse order.
11.10 Replacing the dust filter:
Check the dust filter
Detail 1 Fig. 8
every 40 - 70 working hours or as necessary. Take the filter out of its seat
by unscrewing bolt
Detail 2 Fig.8
. Position the new filter and tighten the bolt
Detail 2 Fig. 8
making sure the
filter-pressure bracket
Detail 3 Fig.8
is sufficiently compressed.
SPECIFIC OPERATIONS FOR ENDOTHERMIC MODELS
50&70 ST
FOR OPERATIONS RELATIVE TO THE ENGINES, IT IS NECESSARY TO READ THE SPECIFIC USE
AND MAINTENANCE HAND BOOK ENCLOSED.
Carry out the operations for checking the engines or changing the while wearing protective nitrile gloves.
Used oil must be disposed of according to the standards enforced by the law.
Normal maintenance involves:
1.
Checking the oil lever every 5 working hours.
2.
Changing the oil after the first 5 hours (follow the indications in the engine handbook for the type of oil to use).
3.
Changing the oil every following 25 hours in the case of heavy duties, or every 50 hours of normal use.
4.
Cleaning the air filter every 25 hours.
Summary of Contents for 50&70 Series
Page 92: ......
