DURASWEEP 50&70
OPERATING MANUAL
V01
TSM - Technological Systems by Moro Srl
Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy
Tel. +39.0434.564167
-
Fax +39.0434.954069
www.tsmitaly.com – [email protected]
31
ADJUSTMENTS
11.5 Centre brush:
To adjust the centre brush
If the machine removes dirt and debris inefficiently or leaves dirt behind, it needs to be adjusted. Lower the centre brush
and proceed as follows:
1.
Remove the protective case
Detail 2 Fig.4
2.
Loosen the bolt
Detail 1 Fig.10
in the slot at the front
3.
Tighten bolt
Detail 2 Fig.10
until the three bolts
Detail 1,
2
and
3 Fig.10
make contact
4.
If the brush is too flat on the ground, loosen bolt
Detail 2
and tighten bolt
Detail 1
.
N.B.:
To ensure the centre brush is correctly adjusted, measure its "
Track
" as follows:
1.
After making adjustments, start the machine up and, without
moving either forwards or backwards, leave it standing in the
same place for at least 10 / 15 sec. with the centre brush lowered.
2.
Turn off the motor, raise the centre brush and move the machine
forwards manually until the mark left by the rotation centre brush
on the floor is visible, as shown in
Fig. 11
.
N.B.:
The width of the track must not be under 3 cm.
11.6 Forward regulation:
If a machine with mechanical forward drive has lost power, regulate the forward drive as follows:
Loosen bolt
Detail 1 Fig. 12
, move the driving wheel
Detail 3
closer to the hub of the driving pulley
Detail 4
and unscrew the threaded adjusting screw
Detail 2 Fig.12
as required.
IMPORTANT:
After regulation the wheel Detail 3
must be as close as possible to the driving pulley
Detail 4 WITHOUT ACTUALLY TOUCHING IT.
11.7 Refuse container:
To carry out this operation, with the machine off, the following
articles are necessary: heavy duty gloves, detergent.
Every 50-60 working hours, or more often if the machine is
used for particular heavy duties, the container must be washed
to avoid the formation of un-hygienic conditions which could be
dangerous because of the high concentrations of bacteria.
Summary of Contents for 50&70 Series
Page 92: ......
