DURASWEEP 50&70
OPERATING MANUAL
V01
TSM - Technological Systems by Moro Srl
Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy
Tel. +39.0434.564167
-
Fax +39.0434.954069
www.tsmitaly.com – [email protected]
20
1
PREPARATION
1.1 Unpacking
Having eliminated the outer packaging, free the machine from the pallet as follows:
1. Release the front wheel brake
2. Remove the sticky tape
Detail C
blocking the handlebar
3. Open the bin
Detail A
and pull out the two handlebar supports
Detail B Fig.1
4. Screw the handlebar supports
Part. B
into the holes
Part. E Fig. 1
5. Screw the ends of the handle into the holes
Detail D
on the supports as shown in
Fig.1/B
6. Take the machine off the pallet: according to the machine weight, written on the CE label, this can be done
in
different ways:
1. With the aid of one or more people provided with gloves, lift the machine, holding it by handle at the front, and
stand it on the ground.
2. With the aid of a slanting board (not longer than 80 cm not to damage the dust flaps) placed against the
narrowest side of the bench, slide the machine down until the floor.
IMPORTANTE:
Check that the machine has not been damaged. In the case of apparent faults, do not attempt to
use the machine and inform the supplier or the manufacturer.
IT IS DUTY OF THE USER TO ENSURE THAT THE WASTE PACKAGING IS DISPOSED OF AND
DESTROYED ACCORDING TO THE SPECIFIC REGULATIONS.
Summary of Contents for 50&70 Series
Page 92: ......
