TSC CPX4P Series, Service Manual

Page: 200 / 232

196
6. Installation
How to Utilize This Installation Procedure Symbols in the Illustration
The frequently-performed operations are described with symbols in this procedure.
Screw
Packaged Item Unused Parts Install Remove Tighten Loosen
Harness
(Common for Guides and
Clamps)
Connector Power Cord
Install Remove Connect Disconnect Connect Disconnect
Power
ON OFF
Check the
sound
Check
visually
Check Push Cleaning
Checking Before Installation
Following shows requirements for the installation site. Therefore, it is desirable to see the installation site in
advance before bringing in this Printer to the user's site.
Checking the Power Supply
1. Printer must be connectable to the outlet that can supply the rated v10/-15% at the specified
ampere or higher.
2. Install this Printer near the power outlet and leave sufficient space around the power plug so that it can
be unplugged easily in an emergency.
Checking the Installation Environment
1. The installation environment must be as described below. Avoid installing Printer near the faucet, water
heater, humidifier, or refrigerator.
•
Operating temperature range: 5 to 35 degrees Celsius
•
Operating humidity range: 10%RH to 90%RH
2. Avoid placing Printer in place exposed to high temperature and humidity, extremely low temperature,
severe temperature changes, and direct sunlight. Especially, avoid placing Printer near fire, out of doors,
in distribution warehouse, or in refrigerator.
3. Avoid installing Printer in an area subject to dust.
4. The room must be well-ventilated properly.
5. None of Printer feet should float. The machine must be held level constantly.
6. When placing Printer on desk, table or the like, it must be sturdy and stable enough to support weight of
Printer.