TS Industrie Saelen GS/VIPER50DS, Operating Manual

Page: 52 / 66

GS/ VIPER 50DS
P R O B L E M - S O L V I N G
In this section, we provide a list of problems, their causes as well as possible Solutions. If you experience a
problem that is not mentioned here, please contact your reseller. Keep your user manual and the serial
number of your chipper at hand.
PROBLEM CAUSE SOLUTION
The engine will not start. -Safety of the coupling acti-
vated.
-Safety of the emergency but-
ton activated.
-The cover is open.
-The safety sensor of the co-
ver is defect.
-Fuse melted in the branch
box.
-The battery is low.
-The power cables have been
damaged.
-The electrical valve that stops
the engine is broken.
-See page 45 and 46
-Turn off the safety.
-Check if the covers are clo-
sed
-Check them (see p.39)
-Replace the fuse.
-Load or replace the battery
-Check the electrical cir-
cuits.
-Check the valve.
Reduced engine power
-Filter blocked
-Blades and hammers blunt
-Replace the filter
-Grind or replace the bla-
des. Replace the hammer
inserts.
INTERVENTION BY A TECHNICIAN ON THE ELECTRICAL CIRCUIT:
Since 2008 all TS Industrie chippers offer the possibility to shunt rotation controller
M18 of the rotor. The technician can then investigate an electrical fault on the
machine without starting the engine (see p. 45). The shunt will stop automatically
when the contact is broken.
Check the TS Industrietechnical customer service in your area or the TS Industrie
after sales department. They will explain how to shunt controller M18.