TS Industrie Saelen GS/VIPER50DS, Operating Manual

Page: 53 / 66

GS/ VIPER 50DS
PROBLEM CAUSE SOLUTION
The engine stops early and
will not start again
-The cover is not properly
closed.
-The safety of the coupling is
activated.
-The red light of the water
temperature is on.
-The safety sensor of the co-
ver is defect.
-There is no fuel left.
-Check if the covers are clo-
sed properly.
-See page 45 and 46
-The radiator is dirty: clean
-Check it (see p.39)
-Add fuel
The belt/roll will not rotate
forward or backward
-The
switch work/
maintenance is in the main-
tenance position
-Fuse melted in the branch
box or the fuse holder on the
large starter cable (see p.42)
-Speed wheel feeding equip-
ment completely tightened
-Hydraulic engine or pump
defect
-Not enough oil in the tank
-Set the switch to the work
position (see p.40)
-Replace the fuse
-Loosen the setting wheel on
the distributor
-Check or replace the defect
part
-Check the oil level
The rotor will not rotate
while the engine is working
-No oil left in the coupling
-Belts defect or insufficiently
tightened
-Rotor blocked
-Check the oil level
-Replace and/or tighten the
belts
-See page 22
The machine has problems
chipping
-Blades and hammers blunt
-Coupling oil level too low
-Belts defect or unsuffi-
ciently tightened
-Anti-obstruction system out
of service
-Grind the blades or replace
them. Replace the hammer
inserts.
-Supplement the oil level.
-Replace and/or tighten the
belts.
-Check the fuses p.42
Feeding in forward opera-
tion is not regulated, not
even below the VarioStress
intervention threshold
-electrical or hydraulic pro-
blem
-Please contact the seller
P R O B L E M - S O L V I N G