TS Industrie Saelen GS/VIPER50DS, Operating Manual

Page: 49 / 66

GS/ VIPER 50DS
D E S C R I P T I O N A N D
M A N I P U L A T I O N
Sensor opening feed for end of chipping
If the user has left the chipper and the time delay ends whilere
there is still material being fed by the belt/roll, a sensorsensor
(A)
is activated for the opening of the feed equipment. It prolongs the
time delay with the same amount of time as the setting wheel.
Example : Delay at 1 = 15sec .: the user leaves after 14 seconds
while there is still chipping material on the feed belt. After 15 sec,
the sensor will prolong the maximum speed during another 15
seconds.
Setting sensor
(A), inlet at
the bottom : 0,70 inch
The duration of the maximum speed must be determined by the operator.
(The
modification is valid as of the next start)
Four different configurations are possible, set by means of the
numbers on the setting wheel.
-Shut down contact and choose the working time with the +
and—keys of the setting wheel:
-
1 = 15 seconds at maximum speed
-
2 = 30 seconds at maximum speed
-
3
= 1 minute at maximum speed
-
4 = 2 minutes at maximum speed
(Do not use n° 0 and 5 to 9)
Example : The figure shows program 1, the diesel engine will idle until
15 seconds after the user has left.
Setting wheel
Access to the setting wheel:
The wheel numeric is protected
from the weather by a waterproof
cover
18mm