TS Industrie Saelen GS/VIPER50DS, Operating Manual

Page: 21 / 66

GS/ VIPER 50DS
WARNING!
If for an unknown reason the shredder has difficulty shredding the
material, and that you have to stop it: do not start the engine
again without having eliminated the cause and cleared the
material out of the shredding rotor!
PUTTING IN SERVICE
1) Check that the cap at the top end of the shaft is open.
2) Place the engine’s accelerator handle at idle.
3) Preheat and start the engine by turning the ignition key.
4) Slightly accelerate the engine’s speed. Let the engine’s
temperature rise.
5) Progressively engage the rotor’s clutch handle upwards.
Make sure the cutting rotor is placed in rotation and that it
is not jammed by residual material
. Never try to clear it
with the clutch,
which would prematurely damage it (see
stopping advice on the next page et page 45)
8) Start shredding.
6) Pull the control bar (1) stopping the feeder right home in rear
position .
7) Put the feed roller in rotation by activating the yellow
control pusher located on the rear left of the branches intake
hopper.
S T A R T I N G