TRUST 500F SPYC@M FLASH
4
3 Batteries
3.1
Inserting the batteries
1.
Open the battery flap.
2.
Insert the two AA batteries as shown on the battery flap.
3.
Close the battery flap again by pushing it downwards slightly and sliding it
closed.
4.
The camera will turn on automatically.
5.
The TRUST 500F SPYC@M FLASH is now ready for use.
Note:
Inserting the batteries incorrectly may damage the camera.
Note:
If you wish to replace the batteries with other non-rechargeable
batteries, only use alkaline batteries.
Note:
If you wish to use rechargeable batteries, only use rechargeable Ni-
MH/1600 mA batteries.
Note:
The camera cannot be turned off manually. It will turn off automatically
after 60 seconds.
3.2 Battery
status
The battery condition is shown on the LCD screen as follows:
The batteries are full.
The battery capacity is low. When the camera is turned on, the
symbol will flash three times and the camera will make a sound to
indicate that the batteries should be replaced. Only a few more
photographs can be taken. To avoid loosing the photographs, all the
photographs should be downloaded onto your computer before
replacing the batteries.
The batteries are empty. When the camera is turned on, this symbol
will flash five times and the camera will turn itself off automatically.
Replace the batteries.
Table 1: Battery conditions
Note
:
The TRUST 500F SPYC@M FLASH has an internal battery for
saving the camera’s memory when replacing the batteries. This
battery has a back-up time of 5 minutes and is charged by the
USB port and the replaceable batteries.
Note
:
To avoid losing photographs, make sure the internal battery is
charged when replacing the batteries.
Note:
Do not use old and new batteries at the same time, because the
old batteries may deplete the new ones.
